First, remove the entire front bumper so that it properly touches the fog lamp baffle. Insert the pry tool into the baffle and carefully move it along the edge, making sure that all the locks are unlocked, and then you can pull it out. Do not use a screwdriver, use only a pry tool. Using a crowbar tool may scratch the bumper.
Cut the fog lamp section along the edge with a hot knife. Give it a little push. Use a file to smooth rough edges after cutting. Remove the luminaire and install the bracket. You can also see if the mounting bracket matches the holes in the lamp. Take a washer, place it on the lamp, and install the mounting bracket on it with two screws. Place the u-clip over the bumper housing area. Place the lamp on the housing and screw it in there.
Put the baffle back in place. Now, since it's not company-installed, there will be some gap between the baffle and the light. But never mind, don't panic. Two wires with connectors will connect to the fog lamp. Use cable ties to secure its position. Open the lower glove box panel and open the top 5 screws. Use the firewall cable ring to push the wire with switch into the passenger side of the car. Install the relay somewhere near the car. A wire with a fuse will connect to the positive electrode of the battery. The black one will be connected to the negative electrode of the battery.
The cord with the Red Scotch lock will be connected to the parking light line of the headlight outlet. This will be the white line. First, remove the socket with the help of the pry tool, pull it out, and then connect the wire. Open the fuse box under the valve cover. Using a crowbar, remove the driver side coin box. Using a drill, punch a hole in it according to the size of the switch, press a button from inside the box to connect the negative wire to the gold pin, the blue wire to the middle pin, and the red wire to the last pin.Put the driver-side coin box back again.Your fog lamp is installed.