A turn lamp is an important indicator which is turned on when a motor vehicle is turning to alert the front, rear, left, right vehicles and pedestrians. Turn Signal Lamp Tube Uses Xenon Lamp Tube, Scm Control Circuit, left and right rotation stroboscopic uninterrupted work. The turn lamp uses the flashlight, realizes the light flashing. Mainly can be divided into resistance wire type, capacitance type and electronic type of three.
The turn lamp is the most important device to show the dynamic information of the car. It is installed before and after the car body, and is opened when the car turns. It provides a guarantee for driving safety. For your safety and the safety of others, please use the turn lamp according to the regulations, let people know in advance what the car is going to do and make good judgments.
When driving to a general grade intersection, the distance between the vehicle and the intersection should be determined according to the width of the road surface, the amount of traffic flow and the speed of the vehicle at the time? Turn on the turn signal at a junction of 30-10 metres. Turn on the turn lamp if turning right and changing lanes to the right. Turn on the left signal if turning left or changing lanes to the left. When turning into a junction with a guide lane, turn on the turn signal before entering the guide lane. Driving too early can give the illusion that the car behind has forgotten to turn off its turn lamp. Driving too late can cause an accident to the car behind or to pedestrians.
When entering or exiting a roundabout, turn on the appropriate turn lamp according to the direction of travel. When the traffic in this lane is not smooth and you need to change lanes, you should look through the rearview mirror to see whether the adjacent lane is free or not. If the traffic in other lanes is not disturbed, you should turn on the corresponding turn lamp in advance, and then change lanes.
Turn the car around, should open the left turn lamp, and pay attention to observe the car before, after there is no car, and then turn around. Turn on your left turn lamp and honk if you need to overtake on a section of the road without a marked solid center line. If you are being overtaken, keep to the right.
When you need to pull over while driving, you should turn on the right turn lamp in advance, and pay attention to the traffic dynamics in the right rear of the car, and then pull over.
When leaving the parking area, you should turn on your left turn lamp and observe the traffic movement in the left rear of your vehicle before driving into the carriageway.