Friends who are new to the car may have many friends who don’t know how to adjust the dimming of the car’s lights. Let’s take a look at how to adjust the car’s lights.
Put the front of the car perpendicular to the wall, about 10 meters away from the wall; turn on the high beam, generally the high beam is suitable, and the low beam is also suitable. It is best not to turn on the low beam, because it is not easy to distinguish whether the high beam is suitable; use a cloth Keep the lights temporarily unadjusted and adjust them one by one. If you want to adjust it yourself, it’s best to adjust it at night, but don’t tune it on the road. It’s not easy to see the effect, not to mention the danger. Try to choose in the community or yard; it’s best to prepare a flashlight, which is not clear at night.
After turning on the high beam, stand in front of the headlight with your feet as close to the headlight as possible. Observe the position of the far light on your feet, take the center of the light as the center point, and write it down; then go to the wall, move vertically to the wall, and Make a mark on the wall according to the position of the light center on the foot; use the screw to rotate the scale teeth of the headlight, be sure to shine the light center on the mark you engraved; if there is no one else in the car when you adjust the light, you can The reason for raising the optical center a little bit is very simple. The empty car should be higher, and the car should sink a little if there are people. The light center is mainly reserved for the amount of light. When you adjust it up and down, you can find that the optical center moves obviously. If you adjust the left and right, the light center is not obvious. I turned a few times before moving a little, so don’t worry if you see that the light center doesn’t move left or right. Continue to turn the screwdriver harder until the light center shines on the mark you engraved.